How To Install Cabinets On Crooked Walls

A building and renovation company that has been operating continuously since its foundation in 2005.

We are proud to help our Clients across Cambridge, London and Norwich areas.

Reading Time: 9 mins

If you haven't moved into a completely new place I am 100% positive y'all are or have been facing this challenge: how to fit cabinets on uneven wall. Bad news are even in brand new places it's not and then uncommon.

Merely good news are there are some piece of cake solutions to that. The short answer is that you have to fix the wall first. Depending on the nature and complexity of an issue information technology might be necessary to plaster the whole wall.

Ultimately build a stud wall on top of the former one and set up plasterboards to have perfectly even surface.

In other cases you lot might take to have out the plasterboards and adjust the studs that are off. Luckily, in most cases it is enough to set up ii or even i wooden batten to the wall. Information technology will a role of spot-on wall.

As a matter of fact, information technology will make the whole process of plumbing equipment the cabinets so much easier and quicker. Of grade it'south impossible to get through all cases.

Nonetheless, below I have put down together some scenarios and solutions to potential issues y'all might have when fitting your kitchen units on uneven walls.

How to Fit Cabinets on Uneven Wall

Every bit mentioned above it's probably the most typical thing on earth that walls in kitchen are not even. Cambridge is full of beautiful and vintage estates which unfortunately are not being spared by ravages of fourth dimension.

It is especially well seen in old houses and flats, only do not take it for granted that in newly built places everything is perfectly prissy and square.

You lot might exist surprised how awry walls can be in brand new buildings.

However, it all can be fixed and prepared to fit your new kitchen equally painless as it mayhap can exist. In virtually common scenarios this problem can be fixed in 3 ways depending on how bad the condition of the wall is.

After it has been taken care of it'southward piece of a block to fit cabinets on the wall.

Building New Wall

In worst example, when your kitchen wall is a complete disaster the most efficient solution is just building a thin wall on top of the old one. The good news is you tin can practice it on your own if you lot take a saw, drill, spirit level and drill commuter.

How practice you practise that? Y'all can start by fixing to the wall ii wooden battens horizontally on elevation and bottom of the wall. Get-go, use the spirit level to check if the wall is straight.

It might be necessary to play around to make it level also.

Adjacent, add vertical studs every 60cm, and then the plasterboards tin can exist properly fixed. Ideally the studs should fit tightly between top and bottom battens.

Some other step is to check and accommodate the studs as necessary to brand them level before fixing to the wall. You lot should as well brand sure to use big enough wall plugs.

E specially if you are planning to apply the structure for something more just fixing the plasterboards.

Now, you are probably wondering how thick the forest should be. And the answer to that is… information technology depends. As always, right? 🙂 i f it should only cover the imperfections of the wall it can be fairly thin or thick/thin as the wall allows to encompass everything up.

Still, if you want to hang cabinets on that wall consider using a little bit thicker pieces of wood so the wall plugs tin set it nicely altogether.

Pro-tips:

• Effort to make sure that edges of the plasterboards will fall in the heart of a stud so they tin can be stock-still
• Bear in listen that sometimes plasterboards do not have exactly 120cm and are not e'er square
• If you are planning to hang something on the wall be sure to add together some additional horizontal battens

Plastering

If your wall can withal be saved and information technology's in moderate good condition the well-nigh efficient solution will be to plaster the whole or part of the wall. In such case, still, I wouldn't recommend doing information technology on your own.

You can probably find plenty of "how-to" videos on that subject and I could fifty-fifty personally recommend a handful of really expert ones myself!

But when it comes to plastering it'southward not that much about knowing how to practice information technology or how to set beforehand. Information technology'south much more about practice than anything else and believe me – if you haven't done it earlier you will lose time and money and it still won't be washed correct.

Source: https://poldabuilders.com/fitting-kitchen-uneven-walls/

Posted by: richardintoommand.blogspot.com

Share this post